7
ATTACHING ACCESSORY DRAWER TO
EXTENSION TABLE
If you have the accessory drawer, remove the drawer (H)
Fig. 5 from the drawer frame (I). To do this hold release
tab (J) and unhook the drawer’s metal glider from the
frame’s metal glider.
Turn drawer frame (I) upside down (as shown in Fig. 6)
and line up four holes in drawer frame — two shown at
(K) Fig. 6 — with the four holes (L) Fig. 7 in the bottom of
the extension table.
Attach the frame to the bracket using four 1/4-20 x 1/2”
(13 mm) hex socket button head cap screws and 1/4-20
flange nuts. Insert the screws down through hole (K) Fig.
6 and tighten underneath with flange nut.
NOTE: Do not re-insert drawer until the table is turned
right side up and attached to the saw.
ATTACHING HANDLE TO DRAWER
Hold the drawer handle (N) Fig. 7A up to the holes (M)
and attach handle to the drawer face with two #8-32 x
1-1/2” (38 mm) round head screws (not shown).
H
FIG. 5
I
FIG. 6
I
K
FIG. 7
L
FIG. 7C
DRAWER STORAGE FOR ACCESSORIES
The drawer (P) Fig. 7C can hold several blades and many
of the accessories that come with your Unisaw.
P
FIG. 7A
FIG. 7B
N
M
M
J
