Operating Manual for Pneumatic Straight/Angle Grinder
BA-NR.: 001 580 302
15 von 31
V06.2021
Health
Danger!
Only wear tight-fitting clothes
during work. Remove all jewellery
before starting work. Always
wear a hair net if you have long
hair!
Caution!
Vibrations can be transmitted
over the entire body, particularly
to
the
arms
and
hands.
Very
strong
or
continuous
exposure to vibration can cause
nerve
and
blood
vessel
disorders!
Dusts from materials with a lead-content coating,
some types of wood, minerals and metals can
represent a health hazard. Touching or inhaling
dusts can be the cause of allergic reactions and/or
respiratory disorders to the user or persons in the
vicinity.
Certain dusts, such as those from oak or beech,
are
considered
carcinogenic, particularly
in
combination with additives used in treating wood
(chromate, preservatives). Material containing
asbestos may only be processed by specialists.
Avoid contact with power sources. The grinder is
not insulated against contact with live parts!
Handling the straight/angle grinder
Risk of injury!
The grinder with tool installed
represents a risk of cutting!
Risk of injury!
The grinder must be held away
from the body when switched on!
Risk of injury!
Before starting work and after
every interruption of the machine,
check the hose and the tool for
damages and wear.
Risk of explosion!
The grinder must not be used in
potentially explosive
atmospheres!
Risk of explosion!
While grinding, dusts can develop
which could form a potentially
explosive atmosphere. Observe
the regulations applicable in your
country
of
use
concerning
materials being processed.
Warning!
In the case of an interruption of
the air supply, switch the device
off immediately! Otherwise, when
the air supply is available again,
the device will start up in an
uncontrolled way.
General
The grinder may only be used with an undamaged
hose! Check the tubes and connections for signs of
damage before starting work!
Only connect the compressed air line when the
grinding tool is clamped and the valve is switched
off!
Pay attention that compressed air stored in the
hose cannot cause the grinder to start up
unexpectedly!
The operating pressure of 6 bar must never be
exceeded during operation!
Before starting work, and after each interruption,
check the unit and grinding tool for signs of
damage. Check for tight seating of the tool in the
collet or on the tool spindle!
Always disconnect the device from the compressed
air supply when changing the grinding tool or
grinding disc and for maintenance work to prevent
the device starting up accidentally!
Complete a 30-second test run before starting to
use the grinder.
Hold the device firmly in your hands!
If the grinder and/or grinding tool have been
dropped, they must be checked for signs of
damage.
The grinder runs on after being switched off. Only
set the unit down after it has come to a stop!
For your own safety, only use tools, accessories
and auxiliary equipment that are specified in the
catalogue or the operating instructions, or that are
recommended by the manufacturer.
Secure the workpiece in a clamping device or a
vice!
Make sure that the equipment is stored before and
after use in a dry atmosphere.
The grinding tools must be carefully stored and
handled in accordance to the instructions of the
manufacturer.
