A
:
9300 S.W. Gemini Drive Beaverton, OR 97008 USA
W
:
www.biamp.com
Desono™
DX-S U-Bracket (SPA-UBDXxxx)
Installation Guide
SPA-UBDX100
- fits DX-S5
SPA-UBDX200
- fits DX-S8
The U-Bracket is a low profile powder-coated marine grade
aluminum design that allows the unit to be connected to a
center suspension post or against the wall, ceiling, or other
flat surface. It can also be mounted to a variety of third party
stand and pole adapters.
A hole drilling template is included in each box to make
installation easier.
1
2
U-Bracket
ClickPlug
Spacers
Bolts
Installation
1. Mount the U-Bracket prior to loudspeaker installation.
If mounting it horizontally on a wall, the slots should
face up - see image at right. Route cable through the
channel.
Sufficient cable should be pulled through
an unused bracket hole to create a drip loop (damp/
wet applications) with enough extra to connect to the
ClickPlug.
NOTE:
If the wall is not finished before the loudspeaker is
mounted, the U-Bracket and cable should be masked with
painter's tape or other masking material.
2. Wire the ClickPlug as shown leaving enough for the
likely mounting angle and a drip loop if necessary. Do
this before mounting the loudspeaker.
Cable / Wire Size
ClickPlug Cable gland nut will accept a 4-8mm (0.15-.3 in)
diameter cable or 2 pairs 1.5mm2 (16 ga) or 1 pair 2.5mm2
(14 ga). For outside or moisture-rich environments - round
SJOW cable or equivalent is advised to provide a weather-
resistant seal in the tightened gland nut.
Tools Needed
• 5.5mm (or 7/32") Hex wrench
• Thin blade or flat screwdriver
Structure Mounting Points
(Hardware not provided)
Cable channel
Thread cable through the gland nut
and barrel into ClickPlug
(2 conductor cable shown)
ClickPlug wired with 2 pairs for
daisy-chained applications
