BH FITNESS YV25, Инструкция по сборке и эксплуатации

Страница: 12 / 32

12
5 Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6 Never use accessories not
recommended by the manufacturer.
7 Do not use the machine if the mains
cable becomes damaged or worn.
8 Keep the mains cable away from hot
surfaces.
9 Do not use the machine outdoors.
10 To unplug the machine, first put the
switch to the “0” position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device (fuse) will be
automatically triggered if the unit is
subjected to abnormal force or heat.
1.- Set switch (L), located on the
casing, to the “0” (OFF) position.
2.- Change the fuse (C) (7 Amp).
3.- Next, set switch (L) to the “I” (ON)
position and the unit will be ready for
use again.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (G) to
Position [1].
Fig.B
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(3) Platform; (56) Platform column;
(59R) Right handle; (59L) Left handle;
(62) Screw M-5x20; (73) Mains cable;
(74) key; (75) key; (76) key 5mm; (77)
Allen screw M-8x20; (78) Flat washer
M-8; (79) Allen screw M-8x55.
Follow these step-by-step assembly
instructions.
At least two people are needed for this
step. When fitting the column, one
person should hold the column while
the other one follows the assembly
instructions. This will prevent any
possible accidents.
1.- COLUMN ASSEMBLY.-
First take the column (56) and put it
into the assembly position, Fig.2,
connect terminal (72), sticking out of
the column (56) with terminal (N)
sticking out of the platform (3).
When you have connected the
terminals push them back inside the
platform (3) to protect them.
Bring the platform column with wheels
(56) up to the platform (3) and attach
securely using screws (77-79), flat
washers (78).
2 FITTING THE HANDLES.-
Take the top left handle (59L), Fig.3,
and insert the ends of the handle into
the tubes on the top column (3), align
the holes and secure the top using
screws (62) and the bottom section
using screws (62).
Now, do the same with the top right
handle (59R).
START-UP.-
Plug the mains cable (63) into the
electric wall socket (220V) Fig.4.
Set switch (G) to position (I), Fig.4.