T5 Treadmill
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhfitness.com • Phone 949-206-8152 • Fax 949-206-0013
15
TROUBLESHOOTING
Table III
PROBLEM CHECKS SOLUTIONS
1. The console does
not switch on.
1a) Make sure that the
machine is plugged in and the
ON/OFF switch is in
position I.
1b) Verify that the console
electric supply cable is
connected.
1a) Plug the machine into the
power supply. Set the switch
to position I.
1b) Connect the console
electric supply cable.
2. The treadmill does not
work.
Check if the electrical outlets
fuse or circuit breaker has
shut off.
Repair fuse or circuit breaker.
Contact a qualified electrician
if required. Plug the treadmill
into a dedicated 110-120V, 15
or 20 Amp outlet to ensure the
treadmill receives the
appropriate amount of current
to function correctly. The
outlet must not supply
electricity to any other device.
3. Walking motion is jerky
on the treadmill.
3a) Check if the belt is
lubricated.
3b) Check the tension on the
running belt.
3c) Check the tension on the
AC motor drive belt drive belt.
3a) Lubricate the sliding belt.
3b) Adjust the belt tension.
3c) Adjust the drive belt
tension.
4. The treadmill belt skews
off center.
4a) Check if the machine is
level on the floor.
4b) Check if the machine
wobbles.
4c) Check alignment of the
front and rear rollers.
4a, 4b) Level the machine.
4c) Align the front and rear
rollers.
5. Error Signal Display
：
Error 1
：
The treadmill can’t
read the speed value.
Error 6
：
Incline motor
doesn’t run.
Error 7
：
Incline is too high
or too low (exceed the
range).
Contact BH Fitness Customer
Service. See Warranty pages
at the end of this Manual.
