BGU SM 300, Оригинальное руководство пользователя

Страница: 11 / 32

11
Fig. 2
1
BEWARE: an excessively backwards leaning position of the splitter during transportati-
on may result into oil leakage from the oil plug. See page 16 for oil change instructions.
At low ambient temperature the oil in the hydraulic circuit will thicken.
In this case, it is recommended to avoid sudden start-up (splitting wi-
thout warming the motor up) that could result into damages and trou-
ble of the hydraulic system.To assure trouble free operation of the hy-
draulic system at low ambient temperature, let the motor run idle and
cycle the unit several times till the oil in the hydraulic loop warms up.
Setting of the main control valve is done in the factory before ship-
ping. The unit comes to you ready for service so that no other adjust-
ment/installation work is required.
5.4 Initial check-up
The log splitter is equipped with safety two-hands mechanical controls
(Fig. 2) designed for the operator to keep both hands free from dan-
ger and from infringing the moving ram zone during the entire split-
ting cycle.
It is strongly recommended to check the operation of the two-
hands control every time before a new use.
To do so, engage both hand levers (1) and hold them down at the sa-
me time to let the push-plate advance all the way to the wedge.
If your system is duly set, the push-plate stops upon releasing of just
one of the two levers while the ram stops its back/forth stroke at once.
On the other hand, the ram must recommence its backwards travel to
the initial start position as soon as the other lever is also released.
Make sure that the ram performs no travel when operating only one
single lever. Check that both levers spring back into their normal posi-
tion when the hand pressure is released.
5.5 Start-up
Before fi rst use, make sure that the log splitter is in good conditions
and that there are no visual damages.
Check all hydraulic hoses, fi ttings and couplings and to detect and re-
pair eventual oil leaks.
Make sure that all safeties and protections are duly assembled on the
machine. Do not attempt to remove or by-pass these safeties!
Should any trouble or unusual behaviour be detected, do not
start splitting wood until these have been fi xed.