BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
9
1. Turn on ignition.
2. Release the park brake.
3. Open the brake completely by selecting EPB-
Audi A8-Deactivate Brake-For Pad Change as
instructed on Page11-12.
4. Change the pads.
5. Activate the brakes as instructed on Page 12-13.
6. Use
UP/DOWN
button to select Adaptation from
Select Function menu and press
Y
button.
7. Wait a few seconds until following screen shows:
8. Use
UP/DOWN
button to enter new pad thickness, and press
Y
button to confirm. If you want to
quit the setting, press
N
button and a "
Command Cancelled
!" message comes up.
9. An "
Adaptation Done
!" message comes up on device screen indicating the setting is performed
successfully. If the setting is not carried out successfully, an "
Adaptation Failed
!" message shows.
Repeat steps above to try again.
10. Wait a few seconds or press any key to return.
11. Turn the ignition off.
4.2 Diagnose Mercedes SBC
The EPB Service Tool is able to deactivate/activate SBC functions, change brake fluid/bleed brake
system, inspect brake air, read/clear SBC trouble codes, and retrieve ECU information on Mercedes
vehicles that are equipped with SBC system.
1. Use
UP/DOWN
button to select SBC-Mercedes
from Diagnostic Menu and press
Y
button to
confirm.
2. Wait a few seconds while the device is
communicating with the vehicle until following
screen shows.
If the brake tool fails to communicate with the vehicles ECU (Engine Control Unit, a "
LINK ERROR
!"
message shows up on the display.
Verify that the ignition is ON;
Check if the brake tool's OBD II connector is securely connected to the vehicle's DLC;
Turn the ignition off and turn it back on 10s later.
If the "
LINK ERROR
!" message does not go away, then there might be problems for the brake tool to
communicate with the vehicle.
Contact your local distributor or the manufacturer's customer service department for assistance.
