SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.l
h
a
t
s
w
s
@
o
f
n
i
:l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
5.1 AC Current Measurement
1. Make sure that “Data Hold” switch is not pressed.
2. Set the range switch to 2000mA, 20A, 200A or 600A
3. Press the trigger to open the transformer jaws and clamp one conductor only. It is impossible to
make measurements when two or three conductors are clamped at the same time.
4. Read the display
5.2 AC/DC Voltage Measurement
1. Connect the black test lead to the COM jack and the red test lead to the V jack.
2. Set the range switch to AC600V or DC600V.
3. Touch the tips of the test leads to the circuit under test.
4. Read the display.
5.3 Resistance Measurement
1. Connect the black test lead to the COM jack and the red test lead to the V
Ω
jack.
2. Set the rotary switch at desired
Ω
position and test leads across the resistor under measurement.
NOTE:
1. If the resistance being measured exceeds the maximum value of the range selected or the input
connected, an overrange indication”1”will be displayed.
2. When checking in – circuit resistance, be sure circuit under test has all power removed and that
all capacitors have been discharged fully.
5.4 How to Use Date Hold Function
On all ranges, you can hold a reading on the display using Date Hold Function.
1. While making measurement, press the Date Hold switch. The last reading remains held on the
display, with a Hold symbol(an arrow mark)shown Date Hold Function.
2. Press the Date Hold switch again to exit from Date Hold Function.
