Bg Radia R-LCRi, Руководство по установке и эксплуатации

Страница: 8 / 12

BG Corp 2005 8
Proper Hookup:
Connections: Two # 10 Phillips head screws and crimp on connectors
are provide for proper hook up. These Phillips Lug screws will be found
on the back PCB (Printed Circuit board) of the loudspeaker.
#10 Phillips marked on PCB to positive (+) amplifier post
#10 Phillips marked on PCB to negative (-) amplifier post
a. 2 crimp-on connectors also can be found on the back PCB with 2 #10
Phillips head screws as the fasteners
b. These connectors can accept a 16-14 awg cable
c. All Radia in-wall loudspeaker are single post connections clearly
or -.
The R-75i and R-8i are connected to one another via a parallel wiring
scheme- either home run to the amplifier or daisy chain in parallel with
one another.
Installation:
1. Cut the proper hole size for the speaker for either vertical or
horizontal applications.
2. If new construction brackets were installed during the construction
phase of the project pull the cable out and connect the crimp on
connectors. If not, run the proper cable and then connect the
speaker wires via the crimp-on connectors.
3. Install fiber-fill within the mounting cavity.
4. Remove the speaker from the plastic packaging,
5. Pull one or both grill end-caps off and remove the grill by pulling it
up an out of the assembly’s channels.
6. Remove the black outer rubber covers on R-75I/R50i/R-40I to
reveal the 1/8” Allen-Key screws to the dog-toggles.
7. Connect the speaker cable and connectors to the speaker
8. Insert the speaker in the cavity.
9. Using the supplied 1/8” Allen-Key bit in a medium clutched screw
gun, engage the dog-toggles and tighten.
10. Test the speaker.
11. Re-install the rubber covers, grills and end caps.
Installation