4. Press and release the number any button on your new remote control that you
want to use to control your garage/gate. This will cause the LED to flash fast. This
indicates that that button on your new remote has been coded. After about 1
second, the LED will continue flashing, but will be flashing slowly.
5. If you would like to code in additional remotes, this is the time to do it. You will
need to start again using the additional remote and complete steps 3 & 4 for each
additional remote.
Whether you code additional remotes or not, once you have
finished coding your remote(s), the LED should be flashing slowly
5. Wait 15 seconds
6. Your new remote control/controls are now programmed
Receiver with digital screen (second type of receiver):
1. Press the “OK” button on your receiver twice. The screen displays “PARA.”
2. Press the “-“ button on your receiver twice. The screen displays “RADIO.”
3. Press the “OK” button on your receiver once. The screen displays “ADJ STRT.”
4. Press the “OK” button on your receiver once. The screen displays “Hidden
Button.”
5. Press the number “3” and the number “4” button on your new remote control at
the same time. Keep them pressed down.
6. Keep holding the buttons down until the screen displays “released”. Let the
buttons go. The screen displays “Desired Button”.
7. Press and release the button on your new remote control that you want to use to
control your gate/garage. The screen displays “OK”.
8.
If you would like to program an additional remote:
When “ADJ STRT” appears,
press “OK” to code an additional remote, and follow the instructions displayed.
9. After coding the remote(s), wait about 30 seconds. Now you remote is coded.
