P a g e
|
3
Overview of System
Please read this entire manual before attempting to install this system.
This system should only be installed by a professional automatic gate installer or access control
specialist dealer.
It is recommended that the system be set up, configured, commissioned and tested on a
workshop bench
before
taken to site for installation.
Site Survey
Before installing this system, you need to be sure that there is good mobile GSM cell coverage in
the area it is to be installed. It is recommended that you conduct a site survey, and check
reception on the site for a GSM network. If reception is poor in the area, then this system is not
recommended. This unit can operate on At&T and T-Mobile networks in the USA.
SIM Card
You will need a SIM card in order to use this system. It should be a regular voice and SMS text
SIM card. Do not use a data only SIM, as this is only for tablets and will not work in the unit.
Power
This system comes with a 15v d.c. power supply. It is recommended that it is located within 12
feet of the intercom and cabled in 14 gauge cable.
15v
1.5amp
power
supply
14 Gauge Power cable
15 feet max
Call box
1) Ensure the SIM has calling credit, and can make and receive
calls on a cell phone.
2) Check that the SIM is not locked to a phone and can be used
in other devices. Call the service provider to unlock it if required.
3) Check that the SIM does not have a PIN code request.
4) You are now ready to begin programming
.
Tip
: 18 gauge cable will not run the unit. You may
experience various issues with performance if the
power cable is more than 15 feet and using thin
cable such as 18 gauge.
The device uses peak current of up to 2 Amps!
If 18 gauge cable has already been installed,
doubling or trebling up cores may be sufficient.
