ENGLISH
INSTALLATION MANUAL
INSTALLATION MANUAL
On the screen is shown:
Mode
Operating mode set
SSID
WLAN network name created by the WI-FI B EBA GATEWAY
[BeBa_Wifi_<Mac
address>]
BSSID
Mac address
Channel
Channel which transmits/receives the board
Security
Security type set for the network operated by B EBA WI-FI GATEWAY
9.1) Step1: U-Link PARAMETER SETTING
The B EBA WI-FI GATEWAY board to be used with dedicated BFT software needed to set the parameters for the U-Link by
clicking on the
[U-Link]
configuration in this installation menu.
Password AES
Password for the AES encryption protocol U-Link.
Length between 8 and 16 characters.
Bft12345
default value
Port:
Port corresponding to the U-link service of the B EBA WI-FI GATEWAY
board.
1111
default value
After changing the parameters click
[Save]
9.2) Step2: Client PARAMETER SETTING
In order to change the default setting of the B EBA WI-FI GATEWAY board to set it as a client click
[Station]
in the installation
menu.
Available
Networks
Shows the list of networks that are visible and accessible from the module
SSID
It indicates the wireless network to connect to. If the network is not visible
by setting
[manual configuration]
in
[Available Networks]
it is possible
to type the hidden wireless network name to which you want to connect.
Password
Password of the WiFi network to connect to.
DHCP
Enable it if is expected that the WLAN to which to connect automatically
associates the IP of the B EBA WI-FI GATEWAY
IP address
Setting the IP address of the B EBA WI-FI GATEWAY board if DHCP is not
enabled.
IP netmask
It sets the netmask of the B EBA WI-FI GATEWAY board if DHCP is not enabled.
IP gateway
Setting the IP address of the router to which to connect if DHCP is not
enabled.
For the changes to take effect, click on
[Apply]
. After that the board is no longer accessible through the browser.
In order to restore the default configuration of the B EBA WI-FI GATEWAY board, see section RESET TO FACTORY SETTINGS.
Note: for correct operation with the BFT software the B EBA WI-FI GATEWAY board must be accessed with a fixed IP and this
can be possible:
- setting it directly on the browser during client setup
- by setting a rule in the router that manages the WiFi network to which to connect that associates the Mac address of the
same IP board.
Note: The data required in order to interface the B EBA WI-FI GATEWAY board with the BFT software is:
-IP of the board
-Port must answer the U-link service
-Password AES
8 - B EBA WI-FI GATEWAY
9
www.BFTGateOpeners.com | (800) 878-7829 | [email protected]
