INSTALLATION MANUAL
INSTALLATION MANUAL
8.1) Step1: U-Link PARAMETERS SETTING
The B EBA WI-FI GATEWAY board to be used with dedicated BFT software needed to set the parameters for the U-Link by
clicking on the [U-Link] configuration in this installation menu.
Password AES
Password for the AES encryption protocol U-Link.
Length between 8 and 16 characters.
Bft12345
default value
Port:
Port corresponding to the U-link service of the B EBA WI-FI
GATEWAY board.
1111
default value
After changing the parameters click
[Save]
8.2) Step2: PARAMETER SETTING Access Point
In order to change the default access point, click
[Access Point]
in the installation menu.
Change the settings if necessary
SSID
WLAN network name created by the WI-FI B EBA
GATEWAY
[BeBa_Wifi_<Mac address>]
Not modifiable
Channel
Channel which transmits/receives the board
If multiple B EBA WI-FI GATEWAY are used in
proximity configured as an access point, reduce radio
interference by selecting different channels for each
of the adjacent B EBA WI-FI GATEWAY. A spacing of
four channels is recommended between the adjacent
B EBA WI-FI GATEWAY (for example, use channels 1
and 5, or 6 and 10).
Security
Security type set for the network operated by B EBA
WI-FI GATEWAY.
Possible settings:
-Open - Open network, without encryption
-WPA-PSK - Network encrypted according to WPA-
PSK Protocol
-WPA2-PSK - Network encrypted according to WPA2-
PSK Protocol
-WEP - Network encrypted according to WEP Protocol
IP Address
IP address assigned to the B EBA WI-FI GATEWAY
IP netmask
Netmask setting
DHCP
Enables/Disables DHCP of the DHCP server
DHCP start IP Address
Value of the first address used by the DHCP server.
5 IP devices max.
To make the changes, click
[Apply]
, after this the board cannot be accessed with the default configuration.
Note: The data required in order to interface the B EBA WI-FI GATEWAY board with the BFT software is:
-IP of the board
-Port must answer the U-link service
-Password AES
9) CASE 2: CONFIGURATION AS CLIENT (FIG. D)
This type of connection allows to manage a U-Link system using the B EBA WI-FI GATEWAY board connected to an existing
WLAN network which is connected to the PC, smartphone and/or tablet always through dedicated BFT software.
1. Connect the PC, smartphone and/or tablet to the SSID network identified by the name
BeBa_Wifi_<Mac address>
(using
WPA2-PSK security type, and the default password BEBAWIFI) defined by the EBA B WI-FI GATEWAY. The Mac address of the
B EBA WI-FI GATEWAY is what is on the label on the B EBA WI-FI GATEWAY board.
The methods for connecting to the WiFi network vary depending on the PC, smartphone and/or tablet and operating
system adopted, to understand how to connect, check the instructions of the device.
2. After connecting to the B EBA WI-FI GATEWAY open the browser (be sure not to have the proxy server active), type in the
address bar the default address
192.168.1.1
of the B EBA WI-FI GATEWAY
It reaches the current configuration of the module page
8 - B EBA WI-FI GATEWAY
