c)
Remove the 2 screws which hold the burner heat shield to the front of
the fire box to allow access to the burner, then remove the 4 off screws
that hold the burner in position. The base of the burner unit can now be
pulled forward, allowing the burner to be removed from the fire box.
See fig. 5 below. If installing into a class 1 chimney, fit the flue
restrictor baffle
Fig. 5
d)
Refer to the fitting instructions for the hearth panel and casting and fit to
the builders opening as prepared to the dimensions stated in section 1.6
e)
With the hearth panel and casting in position, ensure that the hearth is
protected from damage.
f)
Mark out and drill 4 off No 14 (6mm) holes in the back face of the fire
opening in the positions shown overpage in fig. 6
12
Burner Engine
Burner Heat Shield
Firebox
Flue restrictor baffle - held in
position by 4 off screws - only to
be fitted to class 1 flues
