Bezzera B2013, Инструкция по эксплуатации

Страница: 32 / 92

32
MOD.
BEZZERA B2013-C2013 Compact
4. MACHINE INSTALLATION
4.1 Warnings
Installation must be carried out by qualified staff,
according to the instructions supplied by the man-
ufacturer and in compliance with applicable Laws.
The machine should be located and installed in
a place where the use and maintenance are per-
formed by qualified personnel. Can be used the
machine in places used to staff kitchen areas in
shops, offices and other working enviroments;
farm houses; by clients in hotels, motels and other
residential type enviroments; bed and breakfast
type enviroments
4.2 Preparation of system for installation
Prepare the machine’s support on a flat horizontal,
dry, smooth, sturdy, stable surface positioned at
such a height that the cup warming surface is over
150 cm from the ground.
Do not use water jets, neither perform the installa-
tion in places where water jets are used.
In order to guarantee regular operation, the device
must be installed in places where the temperature
is b5 and +32 ºC and the humidity does
not exceed 70%.
If the machine is exposed to temperatures below +
0 °C, proceed as follows:
- ensure that the machine has elapsed 24 hours
in a place where temperature is higher than +
15 °C before turn it on.
The machine is electrically supplied and it needs
the following to operate:
- connection to electric network
- connection to water network
- connection to drain circuit.
4.2.1 Connection to electric network
Warnings :
- The connection to the electric network must be
done by qualified staff.
- The system must be made in compliance with
applicable Laws and equipped with ground
connection.
The machine is provided with power cord without
plug; in the permanent connection to the power
grid, between the equipment and the grid, in-
terpose a safety omnipolar switch with minimum
opening between the contacts of overvoltage cat-
egory III, suitably dimensioned for the load and in
compliance with the applicable standards.
4.2.2 Connection to water network
(Fig. 03)
Make sure that the water supply line is connected
to a potable water network with operating pressure
between 0 and 6 bar (0 - 0,6 MPa).
In case the water network is subject to pressures
higher than 6 bar (0,6 MPa), provide a pressure
reducer.
Provide a water shut-off valve upstream the ma-
chine’s connection.
The water loading connection (Fig. 03; pos. 1) is
supplied with G 3/8” thread.
Warning: Do not open the threaded cap
and boiler’s exhaust valve located be-
side the water loading connection for
any reason: burning hazard. Use only
the new inlet hose supplied
4.2.3 Connection to drain circuit
(Fig. 03)
Connect the rubber discharge tube provided (Fig.
03; pos. 2) to the G 3/4” union and to a previously
prepared open or examinable siphon discharge.
4.3 Instructions relative to the water sof-
tener
(Fig. 04)
Prepare the machine’s connection as indicated in
Figure 4.
For use and maintenance refer to the instructions
relative to the water softener.
A – Connect to the water loading pipe
B – Connect to the potable water network
4.4 Equipotential connection
(Fig. 05)
This connection, foreseen by some norms, has the
function to avoid electric potential differences be-
tween the masses of devices installed in a same
room. This device is equipped with a terminal in
order to connect an external conductor, with eyelet
terminal to be inserted between the two nuts, with
nominal section in compliance with current legisla-
tions.