13
For the doses programming follow the instructions reported to chapter 5.6 of this
manual.
N.B.:
The 1° group automatically programme the 2° group and the 3° group
automatically programme the 4° group.
There is the possibility to select the function "PRE-INFUSION".
Machine OFF. Switch on the machine keeping pressed:
Touch-key
a
(fig. 3) of the 1st group TO ENABLE THE PRE-INFUSION
Touch-key
b
(fig. 3) of the 1st group TO TAKE OFF THE PRE-INFUSION
The system confirms the operation keeping alight the leds "PROG/CONT".
Switch off the machine and then switch it on once again.
Check the desired setting.
The pre-infusion phases you use are the ones you program.
1)
Turn off the water knob.
2) Set the switch (fig. 4) in position 0 and verify if the green light is off .
3) Switch OFF the omnipolar switch.
5.6.1 Dose programming for machine with 4 groups
5.6.2 Pre-infusion programming
5.7 Machine Stop
