12
1) In order to avoid eddies in the boiler, let off steam by turning the relevant
knob (fig. 1; pos. 4).
2) Insert the nozzle into the container with the water to be heated.
3) Turn the steam knob.
The outlet steam depends on the knob turning: the more the knob is turned, the
more the steam is let off .
4) After the steam has been blown off, turn the knob off, take out the container
and clean immediately the nozzle with a damp cloth in order to remove
residual heated water .
1) Place the water container under the dispenser (fig. 1; pos. 9).
2) Turn on the knob(fig. 1; pos. 14) to get the required quantity of water.
To program each single dose (fig. 3; pos. a ÷ d), do as follows: keep the key
[PROG] pressed (fig. 3; pos. e) of the group interested in the dose programming
till the relevant LED flashes.
Within 4 seconds press the required dose (fig. 3; pos. a ÷ d) and when the
quantity has been supplied press again the same touch-pad.
During the programming, only the leds relating to the touch-pad PROG and the
pressed touch-pad are left on.
To program another dose, repeat the same procedure; however, this time the
led relating to the dose previously programmed, will not light up, but that doesn’t
prevent the dose reprogramming .
Programming the first group, you program automatically the other groups. This
first
group only, allows to transmit the programming to the others which can be
programmed also individually.
5.4 Steam Outlet
5.5 Getting hot water
5.6 Dose Programming
