5
RECOMMENDED CURING TIME BASE ON THE BOOST POWER
Due to the high light output of the Slimax Curing Light System, the normal exposure times for conventional
units can be cut in half without compromising polymerization performance.
Beyes Dental Canada TESTING INDICATES THE FOLLOWING RECOMMENDED CURING TIMES:
Universal composite shades A3 and lighter (2-mm depth).....................5 seconds
Universal composite shades A3.5 and darker............................................10 seconds
Bonding agents, universal resin luting cements
and Self-etch, self-adhesive cements....…...................................................5 seconds
Note:
It is highly recommended that curing capability be tested using a Hardness Disk
to ensure a complete cure.
CURING LIGHT CONTROLLER:
The efficiency of your new Slimax Curing Light is designed to provide an entire days use when fully charged.
A fully charged battery will yield 850 ten-second cures.
Boost and Regular Light Output :
The Slimax Curing Light offers you two tiers of light intensity to meet your daily needs
LP = Regular Output
1400 mW/cm2 ± 10%
HP = Boost Output
2000 mW/cm2 ± 10%
Select Output:
1. Press button “2” continuously
2. Press button “1” to select HP or LP
TROUBLESHOOTING
Problem
Cause(s)
Solution(s)
No indicator lights on the controller
• Battery Not Charged
• Battery is improperly connected
√
Recharge the battery
√
Unscrew the battery to clean the
circuit contact dot of the battery and
the two contact pins located at the end
of the unit
The battery does not charge
• Check Power Supply and Charger
Base for proper
connections
• Check that Controller is
seated properly in Charger Base
√
Ensure there is a good connection
electrical outlet and plug
√
Clean the battery electronic contact
and charge needle inside of the charger
base
The controller has not been used for a
long time and will not turn on
• Battery no charged
√
Place Controller in the charger and
re-charge the battery.
Low light intensity
• The light guide may be not clean
√
Clean the light guide and the
protecting glass in the light guide
mounting hole
Cannot activate the light by pressing
the ON/OFF button
• LED light is burned out
√
Call Beyes Dental Canada Inc. for an
authorized service center