BEYES Comfortek, Инструкция по эксплуатации, Страница: 16 / 24

16
8.5 Compressor
1. Open the drainage mechanism at the bottom of the air purge valve to empty the
water inside. (Figure 13)
2. At the end of the day, turn off the machine and unplug the electrical outlets.
3. Loosen the screw on the drain valve below the tank to remove all pressure (a dry
cloth is recommended to avoid getting wet). This will also eliminate condensation
and extend tank life. Don't forget to tighten the screws before starting a new day.
(Figure 14)
4.As for the backflow from high-speed air, the oil in the air is collected in the dirt
cup. It is recommended to drain once a day. Please check the level of the dirt cup
and empty it if necessary. (Figure 15)
Figure 13 Figure 14 Figure 15
9. Troubleshooting Guide
9.1 Error: No Power
1. Ensure the power cord is plugged into a live wall circuit of the appropriate voltage
2. The machine end is firmly plugged into machine
3. The main switch is on
4. Ensure the overcurrent protector hasn’t popped
9.2 Error: The tank will not pressurize
1. Ensure the compressor on/off switch is in the on position
2. Ensure the drain valve is closed
3. Ensure the safety purge valve is closed
4. Check the tank pressure is set correctly
9.3 Error: Not getting the correct pressure at the tools (M4 lines)
1. Check that the correct output pressure is set at the regulator on the compressor
2. Check the drive air pressure regulator