Beyerdynamic Headzone PRO XT, Быстрое руководство по установке

Страница: 13 / 28

- 13 -
english
Note:
Although the surround processing is completely disabled in the “Bypass” mode, the playback volume will still be
influenced by the ”Distance” and “Ambience” parameters. This is because switching between processing and
bypass could otherwise lead to a dramatic increase of volume and therefore damage your hearing. Locking the
playback volume to the ”Distance” and “Ambience” parameters will always provide a convenient volume
balance between bypass and processing mode.
Bypass Status LED
Off = Headzone
® processing activated
Red = Bypass mode
Input Select button
By pressing the “Input Select” button you can switch between the analogue Sub-D , the digital Firewire IEEE
1394 and AES/EBU audio inputs.
Input Select LEDs
Analog LED green
- Analogue inputs are activated
Analog LED red - Analogue inputs are close to clipping
FW LED green - Firewire inputs are activated
FW LED red - Firewire inputs are close to clipping
AES/EBU LED green - AES/EBU inputs are activated
AES/EBU LED red - AES/EBU inputs are close to clipping
Note:
The appropriate “Input Select” LED will light up red when less than 6 dB of headroom is left for at least one
audio input. Separate “Peak” LEDs for every audio channel (except Com channel) are displayed in the Headzone
®
software control panel.
Master volume control
Master control for the headphone volume. When working with the Headzone
® system, always set the master
volume control to minimum and then slightly increase the volume to a decent value.
EarPatron noise level LEDs
Seven LEDs display the achieved EarPatron noise level in per cent.
EarPatron noise level reset button
With this button you can reset the EarPatron noise level to 0%.
Limiter LED
Limiter LED green – Limiter activated
Limiter LED red – Limiter actively limits the output signal
Headphone sockets
Headzone
® PRO XT provides two 1/4" (6.35 mm) jack sockets to connect up to two headphones. As the head
tracker does not operate properly when two headphones are simultaneously used, Headzone ® automatically
turns off the head tracker when two headphones are connected.
Note:
When connecting two headphones, the impedance changes from the device perspective. For calculating the
EarPatron noise level, Headzone
® assumes that two identical headphones are connected. If two different
headphones are connected to the device, the displayed noise level is useless, as it does not represent the whole
impedance of the system.
8
9
10
18
19 20
11
12
13
14
15