Chapter 5. Wired Connection Setting
IP Converter DK103M Installation User Manual
20
If you will see the following information in the opened window:
[DHCP Enabled
– Yes]
,
[IPv4 Address
– xxx.xxx.xxx.xxx]
(where xxx.xxx.xxx.xxx is an IP address value), it means that
your computer is assigned the IP address displayed in the
[IPv4 Address]
line, the subnet mask
displayed in the
[IPv4 Subnet Mask]
line, the gateway address displayed in the
[IPv4 Default
Gateway]
line, the DNS server address displayed in the
[IPv4 DNS Server]
line. Memorize or
write down these parameters.
ATTENTION!
If you forget the network parameters, it is
impossible to return the computer’s network settings to their
original state and to connect it to a local network or Internet after configuring the device.
ATTENTION!
If there is the following information in the
[Network Connection Details]
window:
[DHCP Enabled
–
Yes]
,
[IPv4 Address Autoconfiguration
– xxx.xxx.xxx.xxx]
(where xxx.xxx.xxx.xxx is an IP address
value), it means that wired connection was not established and a DHCP-server did not assign your
computer an IP address. Please check the connection settings or contact your system administrator.
5.2. Changing the Local Network Parameters
The default IP address of the device is 192.168.0.99. To connect to the device, make sure it
is on the same subnet as your computer. Note that each device must have a unique IP address.
ATTENTION!
The device
’s default IP address is
192.168.0.99
. If you use several stations, you need to change their
default IP addresses to avoid IP address conflict.
ATTENTION!
If you are sure that your computer and your device are on the same subnet, you can skip this paragraph
To change your computer current network settings, go to
Start
– Control Panel
(
Pic. 5.13
).