Beverage-Air BZ13 Series, Инструкция по установке и эксплуатации, Страница: 5 / 11

Bi-pin Florescent Lamp Installation / Verification
Prior to applying power to the unit, verify that all lamps are properly installed and fully engaged in
the lamp holders.
Proper lamp engagement is achieved by rotating the lamp 90º from its insertion position until it
“snaps” or “clicks” into place.
Visual verification can be made on units without safety shields by using the identification mark on
the end of the bulb. Properly installed bulbs will have the mark centered between the “halves” of
the lamp holder.
On units with shields, the identification mark cannot be seen. Physically verify that the lamp has
been rotated and locked into place.
See pictures below.
Caution: Improperly installed lamps may cause damage to the lighting circuit.
Beverage-Air shall have no liability whatsoever for equipment or component failures or other
damages or losses which arise as a result of improper installation.
Bi-pin lamp end
identification mark
Pins may not be visible
in actual installation
Properly installed lamp without shield. Verify
identification mark is positioned as shown.
Improperly installed lamp with shield.
Note that pins have not achieved full 90º rotation Properly installed lamp with shield.
Requires physical verification that lamp has
been rotated and locked into place
809-067A