6
4.3 Putting into operation
Our blankets are designed as underblankets only. They must be fitted to the bed between the mattress and
the bed sheet.
1 Leave space for the pillow and put the blanket on the
mattress with the connector at the pillow end, so the
connector is face down under the blanket.
2 Pass tape ‘A’ under the mattress, then up through the
eyelet ‘B’, down under the mattress and tie it tightly into
the eyelet ‘C’.
3 Pass the centre tape ‘D’ under the mattress and tie it
tightly into the eyelet ‘E’.
4 Pass tape ‘F’ under the mattress, then up through the
eyelet ‘G’, down under the mattress and tie it tightly into
the eyelet ‘H’.
Please note: When you tie the tape through the eyelets,
make sure the heated underblanket is not stretched too tightly. The heated blanket should be held in position
by the tie tapes. Do not use the heated blanket if it is folded or creased.
Once you have fitted the heated underblanket on the mattress, put your undersheet on the heated under-
blanket as usual so that the heated underblanket is between the mattress and sheet.
Attention: The electronic components in the controller will normally warm up slightly when the heated under-
blanket is being used. The controller should not lie on or be covered by blankets, pillows etc.
4.4 Switching on
Switch on the underblanket by shoving the slider to setting 1, 2 or 3.
After switching on the temperature setting is illuminated .
4.5 Selecting the temperature setting
Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
WARNING
If the heated underblanket is used continuously (for several
hours) it is recommended to use the lowest setting of the
control to avoid overheating of the user.
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the switch, first.
H
E
C
G
B
A
D
F
0
1
2
3
