Beurer IH 55, Инструкция по эксплуатации

Страница: 87 / 88

87
Electromagnetic Compatibility Information
Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer’s declaration – electromagnetic emissions
The MODEL IH 55 is compliance for each EMISSIONS test specified by the standard, e.g. EMISSIONS class and group.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions CISPR 11 Group 1 The MODEL IH 55 uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
RF emissions CISPR 11 Class B The MODEL IH 55 is suitable for use in all establishments, including domestic establishments
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions IEC 61000-3-2 Class A
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Complies
Table 2
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer’s declaration – electromagnetic immunity
The MODEL IH 55 is compliance for each IMMUNITY test specified by the standard, e.g. IMMUNITY test level.
Immunity test IEC 60601-1-2 test level Compliance level
Electrostatic discharge (ESD) IEC
61000-4-2
±8 kV contact
±2 kV, ±4 kV, ±8 kV, ±15 KV air
±8 kV contact
±2 kV, ±4 kV, ±8 kV, ±15 KV air
Radiated RF EM fields
IEC 61000-4-3
10V/m
80MHz-2.7GHz
80% AM at 1kHz
10V/m
80MHz-2.7GHz
80% AM at 1kHz
Electrical fast transient/burst IEC
61000-4-4
±2 kV
100 kHz repetition frequency
±2 kV
100 kHz repetition frequency
Surge
IEC 61000-4-5
±0.5 kV, ±1 kV line-to-line;
±0.5 kV, ±1 kV and ±2 kV line-to-ground;
±0.5 kV, ±1 kV line-to-line;
±0.5 kV, ±1 kV, and ±2 kV line-to-ground;
Conducted disturbances induced by
RF fields
IEC 61000-4-6
3V
0.15MHz-80MHz
6V in ISM and amateur radio bands between 0.15MHz
and 80MHz
80% AM at 1kHz
3V
0.15MHz-80MHz
6V in ISM and amateur radio bands between 0.15MHz
and 80MHz
80% AM at 1kHz
Voltage dips, short interruptions and
voltage variations on power supply
input lines
IEC 61000-4-11
0% U
T
: 0.5 cycle a)
At 0o, 45o, 90o, 135o, 180o, 225o, 270o, and 315o.
0% U
T
: 0.5 cycle a)
At 0o, 45o, 90o, 135o, 180o, 225o, 270o, and 315o.
0% U
T
: 1 cycle
70% U
T
: 25/30 cycles
Single phase: at 0°
0% U
T
: 1 cycle
70% U
T
: 25/30 cycles
Single phase: at 0°
0% U
T
: 250/300 cycles 0% U
T
: 250/300 cycles
Power frequency
(50/60 Hz) magnetic field
IEC 61000-4-8
NOTE
a) U
T
is the a.c. mains voltage prior to application of the test level;