Beurer IH 18, Инструкция по эксплуатации

Страница: 8 / 12

8
Important
Do not boil or autoclave the masks and air hose.
• Once all components are fully dry, reassemble the
atomiser and place the components in a dry, sealed
container.
Note
Ensure that all parts are thoroughly dried during, and
in particular after cleaning, otherwise there is an in-
creased risk of bacterial growth.
Drying
• Place the individual components on a dry, clean and
absorbent surface and allow to dry completely (for
at least 4 hours).
Material resistance
• As with all plastic components, frequent use and
cleaning of the atomiser and the accessories can
lead to a certain amount of wear. Over time, this can
alter the aerosol properties and may eventually affect
the efficiency of therapy. We therefore recommend
that you replace the atomiser once a year.
• When choosing a cleaning or disinfecting agent, note
the following: Only use mild cleaning or disinfect-
ant agents in the quantities recommended by the
manufacturer.
Storage
• Do not store the nebuliser in a damp atmosphere
(e.g. in the bathroom) or transport it together with
damp objects.
• Store and transport the nebuliser away from direct
sunlight.
• Store the device in a dry place, if possible in its origi-
nal packaging.
9. Disposal
In the interest of environmental protection, do
not dispose of the device in household waste.
Please dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Electronic
Equipment).
If you have any queries, please contact the appropriate
local authorities.
10. Troubleshooting
Problem/Ques-
tion
Possible Cause/Remedy
The atomiser
produces
little or no
aerosol.
1. Too much or too little medicine
in the atomiser.
Minimum: 2 ml,
Maximum: 8 ml.
2. Check that the nozzles are not
blocked If necessary, clean
the nozzle (e.g. by rinsing).
Use the atomiser again.
CAUTION: Only poke imple-
ments through the fine holes
from the underside of the
nozzle.
3. The atomiser is not held in an
upright position.
4. The medicine solution is
unsuitable for nebulising (e.g.
too thick).
The medicine solution should
be specified by the doctor.
Output is too
low.
Hose kinked, filter blocked, too
much inhalation solution.
Which
medicines are
suitable for
inhalation?
Consult your doctor.
Essentially all medicines that
are suitable and approved for
device-based inhalation can be
inhaled.
Some inhalation
solution
remains in the
atomiser.
This is normal and occurs for
technical reasons. Stop inhala-
tion if you hear a notable differ-
ence in the noise of the atomiser.
What special
steps should be
taken for babies
and children?
1. In babies, the mask should
cover the mouth and nose to
guarantee effective inhalation.
2. In children, the mask should
also cover the mouth and
nose. Nebulisation next to a
sleeping person is not suitable
because insufficient medicine
reaches the lungs.
Note: Children should only use
the device with help and under
supervision of an adult. Never
leave a child alone with the
nebuliser.
Inhalation with
the mask takes
longer.
This is for technical reasons.
Less medicine is inhaled per
breath through the mask holes
than using the mouthpiece. The
aerosol is mixed with ambient air
through the holes in the mask.