Beurer BC 54, Инструкция по эксплуатации

Страница: 12 / 24

12
Selecting the user
You have 2 memories, each with 60 memory spaces, to
enable the separate storage of measurements for 2 dif-
ferent people.
To select the corresponding user memory, press the M1
memory button (for user ) or M2 (for user ) on the
switched-off device. Confirm your selection by pressing
the START/STOP button .
Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• Press the START/STOP button to
start the blood pressure monitor. All
displays will illuminate briefly.
The blood pressure monitor will begin
the measurement automatically after 5
seconds.
The cuff automatically inflates. The
measurement itself is taken during the inflation phase.
As soon as a pulse is found, the pulse symbol is dis-
played.
You can cancel the measurement at any time by
pressing the START/STOP button .
• The systolic pressure, diastolic pres-
sure and pulse rate measurements
are displayed.
• appears if the measurement could
not be performed properly. Observe
the chapter „9. What if there are prob-
lems?“ in these instructions for use and repeat the
measurement.
• Press the START/STOP button to switch
off the blood pressure monitor. The measure-
ment is then stored in the selected user memory.
If Bluetooth ® data transfer is activated, data is trans-
ferred after pressing the START/STOP button .
The Bluetooth ® symbol flashes on the dis-
play. The blood pressure monitor now attempts
to connect to the app for approx. 30 seconds.
The Bluetooth ® symbol stops flashing as soon as a
connection is established. All measurement data is au-
tomatically transferred to the app. Once the data has
been successfully transferred, the device switches off.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth ® symbol goes out and the
1 2
3
4
5
6
7
8
9
10
11