8
ADJUSTMENTS
For Tape Width
The adjustable roll guides in the tape basket should be properly set for the width of tape
being dispenses. The roll of tape should be centered between the frames by threading the
tape loosely between the roll guides which engage in slots in the basket and roll guide
separator.
To set the roll guides in position, lift them out of the slots in the basket and tie rod. Slide
to the desired position and drop the guides into slots in the bottom of the basket
(see
figure # 5).
Figure # 5
Water Level Adjustment
The amount of water required for proper moistening of different grades of tape will
differ. Heavier glues or reinforced tapes will normally require higher levels of water.
Water level is controlled by water level adjustment screw located in the projecting
portion of the water tank
(see figure # 6).
Figure # 6
Water Adjustment Screw
To raise the water level, turn the screw out in the counter clockwise direction. To
decrease the water level, turn the screw in the opposite direction.
Repeat Length Stop
Repeat lengths: The Better Pack® 333 Plus is equipped with a feed stop. To set for
desired length, pull outwardly on the feed stop know until the pin disengages the hole in
the drum skirt. Then slide the feed stop assembly until the length desired is set on the
scale just above the feed stop assembly. Release the knob, being sure the pin on the feed
stop engages with the proper hole in the skirt
(see figure # 7).
Figure # 7
Adjustment Knob
