11
Crank Handle
If desired, the crank handle can be reversed.
Pressure Plate Weights (see figure # 10)
The pressure plate, which rests on top of the brushes, has removable weights. The
number of weights can be varied to suit the tape being dispensed. Heavy weight tapes
require more weight inserts than lighter tapes. The suggested number of weights is a
follow:
35 lb. kraft tape:
0 to 1 slug
60 lb. kraft tape:
1 to 2 slugs
Reinforced tape:
2 to 3 slugs
The weights can be added or removed by pushing them in or out from each side. If the
machine consistently jams, there is too much weight on the pressure plate and some
should be removed.
Figure # 10
Weights
To Clean Blade
Where reinforced tapes are used, it may be necessary to clean accumulation of laminate
from the cutting blade from time to time. To clean the blade, follow these simple steps:
a.
Remove water bottle and water tank assemblies.
b.
Depress rocker stop rod protruding from the right side of the machine with right
hand and keep it in this position until the blade (blade assembly) has been
released
(see figure # 11).
c.
Reach inside the machine where tank was removed, pull knife assembly down and
swing out to cleaning position
(see figure # 12).
d.
To clean blade, wipe of with suitable solvent.
DO NOT SCRAPE WITH
HARD OBJECTS as resulting scratches will quickly accumulate adhesive.
When adhesive is removed, wipe with lightly oiled cloth.
e.
Re-insert the blade to cutting position by depressing rocker rod. Tip the blade up
into cutting position and push upward so the blade will come between the
stationary blade rollers. Release rocker stop rod.
f.
Try feeding and cutting tape to check if parts are in proper position.
g.
Install tank and water bottle.
