Bettcher AutoEdge, Инструкция по эксплуатации/Перечень запасных частей

Страница: 35 / 84

Maintenance
BETTCHER
Industries, Inc.
Manual No. 185321
June 15, 2018 Maintenance
Operation and Maintenance Manual
5-11
Cleaning the Steeling Device Assembly (Continued)
Cleaning the Steeling Device Mechanism Continued:

Pull the steeling link and solenoid spring out of the link housing.

Use a clean lint free rag to wipe out the bore of the link housing and to clean the seal at the end of
this bore
(do not remove the seal unless it is worn and needs replacing) .

Wipe clean the spring and the steeling link, especially the slot in the link.

Inspect the roller of the alignment pin for excessive wear. If there is a flat on the roller, or if the
groove on the roller is deeper than .150 inch diameter (3.8mm), replace the alignment pin.

Install the spring back into the link housing.

Apply light oil (mineral oil, do not use silicone oils) , to the sliding surfaces, the slot of the
steeling link, and to the roller of the alignment pin.

Be sure the solenoid rod, which is pinned to the steeling link, is clean and dry.

Hold the steeling link so the slot is aligned with the side hole in the link housing, slide the
steeling link into the link housing until the slot is visible through the side hole.

Insert the alignment pin into the hole and release the steeling link.

Slide the steeling handle back up onto the alignment pin and tighten the screw.

Work the steeling assembly in and out a few times to ensure it slides freely, wipe off any excess
oil.
Handle
Alignment Pin
Solenoid Spring
Solenoid Rod
Steeling Link
Seal
Slot
Link Housing
Side Hole in
Link Housing
COMPANY
CONFIDENTIAL