2.
3.
Installation Guide for Betta 3000 Straight Drop
Multi Stop Awning
– with Brackets
Please Note: These instructions should be read thoroughly before installing.
This is a guide to assist in the installation and care of your external awnings. Betta Blinds and Awnings do not
guarantee the accuracy of the information contained in this guide. We recommend an experienced expert installer
to rely upon their own skills. This is based on general knowledge concerning the assembly, materials and working
process of the external blinds, which is known to us at the time of printing this guide, consequently, is subject to
change and Betta Blinds and Awnings specifically reserves the right to change this guide without notification.
Ensure all components are included in your packaging, before proceeding to install:
Side channels x 2
Awning
Channel end cap
(if required)
Pull down ring
(if required)
Pull down stick
(if required)
You will also need: screws, plugs, drill, hammer drill (if drilling into concrete), measuring tape, spirit level, shifter,
rivets, rivet gun (if required), dyna bolts (if required)
If installing on a brick wall NEVER put the screw into a mortar line.
If the position, you need to drill is over a
mortar line move up to the centre of the brick above that position.
Check the size of your blind against the label, which will be attached to the packaging.
1.
FACE FIT
, attach the side channel with the snap in recess facing outwards. Pre-Drill holes through in-fill part of
the channel. Place channel against post/wall and mark holes
2. Pre-drill all holes and plug if needed. When all holes are drilled, position the channels, and fasten with
appropriate fixings. Repeat these steps for other the channel.
3.
REVEAL FIT,
attach the side channel to the inside of the post/wall, with the snap in recess facing backwards.
Pre-Drill holes through the channel. Place channel against post/wall and mark holes
4. Pre-drill all holes and plug if needed. When all holes are drilled, position the channels,
and fasten with appropriate fixings. Repeat these steps for other the channel
5. ADJUSTING SPRING: Lock spring and attach a shifter to the Pin.
refer to picture 2.
Wind the shifter clockwise to apply tension. Use the size chart to determine how many
turns of tension are required.
Link to Spring Tension Chart at the bottom of this
guide
. Do
NOT
let go of the shifter while tensioning as the spring has a lot of force in
it. Do
NOT
try and over tension the spring. When the right amount of tension has been
applied, drop the holding tab down and wind the spring back until it engages the pin
6. Install blind into brackets
NB: Spring end/lock off pin should be on the
left side.
7. If FACE fit snap the infill cover plate into the recess
refer to picture 3
8. Twist bottom rail and roll down and test operation.
Caution: Like all outdoor blinds, it is prudent to retract the blind in the presence of strong winds.
