User manual
BETSO WTCS-1
This function enables or disables WTCS-1 to perform calibration to time code precision of
time code source during jamming.
OFF
Jamming calibration is turned off
ON
Jamming calibration is turned on
Ultimate advantage of jamming calibration feature is, that WTCS-1 will be in
much better synchronization to time code source, when this feature is enabled.
E.g. standard precision of WTCS-1 after GPS calibration is +/- 0.05 ppm.
Considering that industry standard of other manufacturers is much worse around
+/- 0.5 ppm and taking in account aging of up to +/- 1 ppm and other factors as
temperature etc..., total error can be significantly more than +/- 1 ppm. This
error will not arise, when jamming calibration is turned ON, with this feature
WTCS-1 can get in sync with time code source to precision of +/-0.1 ppm.
8.3
Wireless
In this section of menu there are located all settings related with wireless behavior of
WTCS-1.
8.3.1
Unit type -
setting of wireless behavior of WTCS-1
Menu / Wireless / Unit type
This function allows to choose wireless behavior of WTCS-1. On of the following settings
can be used:
RF OFF
WTCS-1 doesn't use wireless transmission and works in cable mode
TX
WTCS-1 is configured to transmit time code on one of the
selected channel. All RXs on the same channel will jam to TX
RX
WTCS-1 is configured to receive time code on one of the
selected channel and jam to transmitting TX. To identify each RX in
the wireless network, one ID number has to be selected in the range
of
ID 1 ... ID 20
When WTCS-1 is used as single device on the set, we recommend to use RF OFF
mode to save battery life.
13
©
Copyright BETSO ELECTRONICS s.r.o.
