6.2 Setting the rubber resistance disc
• Sollten im Laufe der Zeit Ungenauigkeiten bei der Zählung entstehen oder Banknoten •
If, over time, there are inaccuracies in counting or banknotes are no longer easily fed into
the device, this could possibly be due to wear of the resistance disc. It then either needs
to be adjusted or replaced.
• If the resistance disc shows signs of wear, turn the adjustment screw anticlockwise and
carefully lift the banknote feed. A distance of approximately 0.5 mm is required between
the banknote feed wheel and the resistance disc to ensure the necessary friction for the
banknote feed.
Please note: If there are errors in the counting process it is recommended that you turn the
adjustment screw one or two rotations while the device is operational.
• If the rubber of the resistance disc shows signs of severe wear, press the disc with your
thumb and remove it. Turn the disc around or replace it.
• The resistance disc then needs to be replaced in its original position. Observe the exact
position of the left and the right side.
• After replacing the disc, switch the device back on and place a banknote in the feed. If
the disc has been positioned correctly the banknote will be fed in properly.
11
Cause
The left counter sensor is dusty or damaged.
The right counter sensor is dusty or dama-
ged.
Severe fault of the magnet function or faulty
circuit.
Damaged UV sensor or circuit.
The sensor of the banknote feed is dusty or
damaged.
The sensor on the output tray is dusty, not
centrally aligned or is damaged.
Remedy
Clean or exchange the sensor
Clean or exchange the sensor
Clean the magnet head or wheel or
repair the circuit
Exchange the sensor or repair the
circuit
Clean or exchange the sensor
Clean, adjust or exchange the sensor
Error code
E1
E2
E3
E4
E5
E6
7.0 Trouble shooting
Cause
UV testing or device stop for detecting counterfeit notes
(for UV and UV/MG models)
Magnet testing or device stop for detecting counterfeit notes (for
MG and UV/MG models)
Width detection below level 3 or over 5 mm and device stop
(optional function)
Detection of connected banknote and device stop
Detection of half banknote and device stop
Double banknote detection and device stop (optional function)
Error code
CF 1
CF 2
dd
EC
Eh
Ed
7.1 Error messages
-BJ05_Anleitung engl. 01.11.2006 8:30 Uhr Seite 11
