BACK OF MACHINE
TOWARD OPERATOR
RED
WIRE TO
SCRUBBER
BLACK
WIRE TO
SCRUBBER
FRONT OF MACHINE
figure 1
BATTERY INSTALLATION AND CHARGING
- 8 -
BATTERY INSTALLATION
x
Turn off all switches.
x
Drain solution tank and recovery
tank.
x
Disconnect recovery dump hose
from hooks on rear of machine
so that recovery tank can lift.
x
Lift recovery tank lid and tilt up
recovery tank.
x
Install batteries as shown on
figure 1.
BATTERY CHARGING
x
Place the charger on a safe place. Make sure that air can circulate
around the charger. Do not get the charger wet.
x
All switches on scrubber must be off.
x
Do not remove battery caps (the caps are vented).
x
Do not charge scrubber in a wet area.
x
Do not stand in a wet area when plugging in charger to the 110 volt
receptacle or plugging into the scrubber.
x
Connect the charging plug from the charger to the charging plug on the
back of the scrubber (item 16)
x
Plug in the charger to a properly grounded 110 volt receptacle.
x
Indicator needle will rise and then will fall slowly as batteries charge.
x
Charger will shut off automatically when batteries are fully charged.
