3
CHECKS AND MAINTENANCE
37
USA
CHECK THE LEVEL OF THE REAR
BRAKE FLUID
Check the level of the brake fl uid through
sight
D
. The level of the fl uid should never
fall below the mark in the sight.
RESTORING THE LEVEL OF THE
REAR BRAKE FLUID
To restore the level of the brake fl uid, un-
screw cap
3
and pour in brake fl uid until
the level reaches the mark in sight
D
.
WARNING
We recommend using DOT 4 brake fl uid.
Should this fl uid be unavailable, use DOT
5.1 fl uid instead. Do not on any account
use DOT 5 brake fl uid. This is a purple fl uid
with a base of silicone oil which requires
special seals and tubes.
WARNING
The brake fl uid is extremely corrosive. Take
care not to spill it on the paintwork.
BLEEDING THE REAR BRAKE
To bleed air from the rear brake circuit,
proceed as follows:
•
Remove the rubber cap
E
from the valve
F
.
•
Open the sump cap.
•
Insert one end of a transparent tube into
a container.
•
Pump with the brake lever 2/3 times and
keep the lever pressed.
•
Unscrew the valve and let the oil drain.
•
If are still visible in the tube repeat above
operation until obtaining a continuous
outfl ow of oil within no air bubbles.
•
Close the valve and release the lever.
NOTE:
during this procedure, continuously top uo
the brake pump thank to replace the oil that
is out fl owing.
•
Remove the tube.
•
Replace the rubber cap.
E
F
D
3
