Beta Rev 4T, Руководство пользователя

Страница: 29 / 37

28
betamotor.com
3
D
A
F
Maintenance and checks
ENGLISH
COOLANT
Check the level (this must be done with a cold engine)
as follows:
- Remove the grille (D).
- Unscrew the filler cap (A) and visually check the fluid
level.
- If the level is near the bottom of the tube, add fluid as
follows:
- Add the coolant to the system through the radiator.
- Undo screw F located on the left-hand side of the cyl-
inder head until the coolant comes out of the bleed
hole.
- Tighten the bleed screw and continue pouring the liq-
uid into the radiator until it reaches the flared section in
proximity to the filler cap.
The capacity of the circuit is given in the table on page 7.
Use the fluids recommended in the table on page 13.
CAUTION
To prevent scalding, never unscrew the ra-
diator filler cap when the engine is hot.
CHECKS AFTER CLEANING
After you have cleaned the motorcycle, it is good practice
to:
- Clean the air filter (as described on page 24).
- Get rid of any water from the inside of the carburettor
float bowl, by unscrewing the drainscrew on the carbu-
rettor itself.
Note:
This must be done with the reserve tap closed.
- Grease the chain.
BRAKE ADJUSTMENT
Front brake
The front brake is of disc type with hydraulic control, and