Beta Marine BV1903, Руководство по техническому обслуживанию оператора

Страница: 51 / 56

42
All goods are offered and supplied in accordance with our ’General Terms of Tender Sale’. 2
Maintenance-free Batteries and deep-cycle Batteries
60
Gell Batteries
60
Conventional Batteries
-20
12
20 0 40
Volt
14
13
16
15
15
13
-20
12
14
20 0 40
Volt
16
1 - OFF
2 - ON
C
DIP-switch
positions
U2
U1
1 - ON
2 - OFF
C
U2
U1
DIP-switch
positions
60 -20
13
12
20 0 40
15
14
Volt
16
U1
1 - OFF
2 - OFF
U2
C
DIP-switch
positions
DIP-switch
LED
The graphs below illustrate charging voltages for different battery types.
Cover removal for resetting of DIP switches
U1 = Mode B (Orange lamp)
U2 = Mode C (Green lamp)
Note:
ensure all batteries are switched off, controller is
disconnected from wiring before removing any covers.
Voltage setting for battery charge is done through the
two DIP switches inside the controller. Remove the
cover by removing the top four screws and loosening
the bottom four. This cover is sealed on to prevent
water ingress, this seal must be broken for cover
removal.
Set the dip switches to the required settings as
illustrated on the charts opposite.
Re-seal controller with silicon sealant or equivalent
after setting switches.
As standard the controllers are supplied to Beta Marine
to suit lead acid batteries.
If in doubt on battery type check with battery supplier
before fitting controller. Beta Marine are not
responsible for incorrect switch setting for each
installation.
THIS CONTROLLER SHOULD NOT BE MOUNTED ONTO THE ENGINE BODY.