
17
Problem: Battery quickly discharges
Possible Cause
Solution
High load and insufficient
Reduce load or increase charging time. Large domestic battery
running:
banks subject to high electrical loads will take a considerable
time to recharge from a single alternator.
Low electrolyte level:
Top up.
Fan belt slipping - black dust in
engine compartment, engine
compartment temperature too
Adjust tension / replace belt with a high temperature type and /
high:
or improve engine compartment ventilation.
Alternator defective:
Check with Agent.
Battery defective:
Replace.
Poor wiring connection:
Check wiring system.
Problem: Transmission noise
Possible Cause
Solution
Check gearbox oil level:
Top up.
"Singing" propeller:
Check with supplier.
Drive plate rattle at tickover:
Check engine rpm (must be 850 rpm minimum in gear).
Worn drive plate:
Change.
Propeller shaft hitting the
Move shaft back to give at least 5mm clearance (Type 12/16
Gearbox half coupling:
couplings only)
Problem: Vibration
Possible Cause
Solution
Poor alignment to shaft:
The alignment must be accurate even if a flexible coupling is
used (see section 3 ALIGNMENT).
Flexible mounts not adjusted
correctly to take even weight:
Check relative compression of each mount.
Flexible mount rubber perished: Replace. (Diesel or oil will eventually perish most rubbers.)
Loose securing nut on flexible
mount:
Check alignment and then tighten the nuts.
Insufficient clearance between There must be at least 10% tip clearance between propeller and
the propeller tip and the bottom bottom of the boat (ie 10% of the propeller diameter as
of the boat:
clearance). Refer to boatbuilder.
Loose zinc anode on the shaft: Tighten or replace.
Worn cutless bearing or shaft: Replace.
Weak engine support/bearers: Check for cracked or broken feet.
Problem: Morse control cable will not fit
Possible Cause
Solution
Fitting incorrectly
Cables are being fitted the wrong way around, switch over and fit
the opposite way.
Содержание BV1903
