![Bestway 54113 Monaco Скачать руководство пользователя страница 17](http://html.mh-extra.com/html/bestway/54113-monaco/54113-monaco_owners-manual_2741561017.webp)
MAX.
MIN.
X
Connect the pump to the spa by lining
up the letters (A to A, B to B and C to
C). Securely hand-tighten the adapters.
Check all rubber seals are in place.
5.
Using a garden hose, fill the spa to the water level between maximum and
minimum printed on the spa wall.
NOTE:
Before filling, ensure the
bottom drain valve is secured. To avoid
pump failure, water level must reach
the minimum water line but not exceed
the maximum water line.
8.
To heat the water, put the cover on, lock the clips, and push the heat button (see page 18).
WARNING:
Do not run the Lay-Z-Massage system when the cover is attached, air can
accumulate inside the spa and cause irreparable damage and bodily harm.
WARNING:
This spa cover is not a safety cover and is not a
substitute for adult supervision; children must be supervised
around the spa at all times.
Note:
We recommend you take a shower before using your
Lay-Z-Spa, as cosmetic products, lotions, and other residues
on the skin can quickly degrade water quality.
9.
Remove the two stopper
caps from the inside of the
spa’s inlet and outlet pipes.
6.
Screw the filter set to the inside of the
spa’s outlet pipe.
NOTE:
Must screw in
lower position.
NOTE:
Do not sit on the
filter set.
7.
NOTE:
Before use the
Lay-Z-Spa Palm
Springs, always make
sure that all of the
inflatable chambers are
properly inflated and
that there are no folds.
Open the top leatheroid cover and
reverse. Insert the inflation hose
onto the valve to inflate. When the
inflation is finished, close the valve.
NOTE
: Pressure gauge is for
inflation purpose only, and the
value of the pressure gauge is
just for reference, should not be
used as a precision instrument.
Spa
Cover
4.
2
1
Ensure that the inner spring valve is
not depressed.
(
if depressed, press
the spring valve and turn counter
clockwise
)
Attach the pressure
gauge onto the hose of SPA pump,
inflate the spa to 0.008MPa (1.2PSI)
Unscrew the
air-valve on the
spa wall.
1
2
NOTE
: Do
not use an air
compressor
to inflate the
pool.
Use the inflation hose to
inflate the chambers 1on
the spa and 2 on the
cover.
S-S-002097
17