user’s instructions
23
English
7. Push the combi nozzle, or any other accessory,
to the end of the tube (3c). You can use the
comb nozzle or other attachments also slide on
the handgrip of the hose. See Figure 3b.
8. Press the foot button on the nozzle to set the
combi nozzle for use on hard or soft surfaces,
see Figure 3c. For use on hard surfaces, press
the foot button on the combi nozzle to extend
the brushes. Lift the button for use on soft
surfaces.
Accessories
This vacuum cleaner is supplied with one combined
accessory:
• a crevice tool with a narrow nozzle, which
you can use to clean radiators, window
frames, crevices, small openings, and
similar;
• a dusting brush, which you can use to clean
delicate or irregular surfaces, furniture,
Venetian blinds, and similar.
operAtion - storage after use
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in;
the power cord will automatically rewind onto
the reel.
Guide the power cord whilst it rewinds, since
otherwise the cord could become tangled or the
plug could strike the back of the appliance. Take
hold of the power cord near the mark, and allow
it to gently slide through your fingers back into
the appliance, see Figure 5.
3. At the back of the vacuum cleaner you can
find a slot for the combination nozzle. Slide the
combination nozzle into the slot. This avoids
the need to dismantle the vacuum cleaner after
use; you can store the assembled appliance
and retrieve it again quickly when you need it.
cleAninG And MAintenAnce
1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure no
moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And MAintenAnce - changing the dust bag
1. Change the dust bag immediately once the ‘dust bag full’ indicator turns red, see Figure 7.
It is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be cleaned.
3a
3b
3c
3d
