WrapAround™ Windjammer™ – Installation Instructions
Rev. C 0910
80035 pg. 3
Fold the front seats forward and locate the “Z”
Channel in the parts kit. Orient the channel so that,
when installed, the opening will be down. Place the
channel on the vertical face of the riser between
the front and rear fl oors, centered in the fl at area in
the middle of the vehicle. The top edge of the chan-
nel should be fl ush with the top of the riser. Use
the holes in the channel as guides to mark, center
punch and drill fi ve 1/8" holes. Install the channel
using the fi ve #8 x 1" Pan Head Screws from the
parts kit.
Check for wiring and
fuel lines before drilling
holes in riser.
It is easier to drill holes by either slitting
the carpet with a 1/2" “X” shape to ac-
cess the sheet metal, or center punch through the
carpet, remove the carpet and drill the necessary
holes - then add smaller slits in the carpet to access
the holes for attachment.
After drilling the holes for the “Z” Channel in the fl oor
riser, put silicone sealer on the holes before installing
the channel with the screws.
If the vehicle is equipped with a factory console, it
will be necessary to leave the center screw out of the
channel.
“Z” Channel
Riser
Rear Floor
#8 x 1" Pan
Head Screw
Rear
Floor
Riser
Front
Floor
Rear Floor
“Z” Channel
Riser
Front Floor
Install “Z” Channel
Loosen the knobs that secure the Door Surround to
the vehicle to allow the surround to lean toward the
rear of the vehicle.
Roll the plastic strip
along the edge of the
WrapAround™ Wind-
jammer™ into the
channel in the Door
Surround on each side
of the vehicle.
Place the Door Sur-
round back into position
and tighten the knobs.
Secure Windjammer™ to Door
Surround
Roll Plastic Strip
into channel on
Door Surround
