TrekStep Side-Mount™ – Installation Instructions
Rev. A 0312
75407 / 75408 pg. 7
Make sure that the Step is level with the
vehicle body when it is in the up position.
If it is not level, you may need to adjust the Side
Mount (Step 7) by selecting the holes that level the
Step.
Use the M6-1.0 x 20 Socket Head Cap Screws to
mount the Step to the Linkage Assembly.
Install Step
M6-1.0 x 20 Socket
Head Cap Screws
Once the Step is installed on the vehicle, you may
adjust it as desired.
If necessary to adjust the height, use the two (2)
1/4" Spacers provided. Remove the M10-1.5 x
45mm Hex Bolts installed in Step 4 and place the
1/4" Spacers between the Frame Mount and the
Linkage. Reinstall the Hex Bolts.
When the Step is in the desired position tighten all
nuts.
Step Adjustment
Adjust Step if Necessary
Linkage
1/4" Spacer
