Supertop for Truck Installation Instructions
Rev. G 0713
76303 pg. 4
Install Belt Rail Assemblies
Locate the Clamps in the parts kit. Use two clamps
to secure each Belt Rail Assembly to the vehicle.
Place a Clamp as close to each end of the Belt Rail
as possible. Fully tighten the bolt on each Clamp.
Repeat this for both Belt Rail Assemblies.
Belt Rail Assembly
Rear
Clamp
Slide a Bow Tie Down Strap onto each of the Front
Bow Halves. Slide the two halves of the bow into a
Bow Coupler.
Assemble Front Bow
Bow Coupler
Front Bow Halves
Bow Tie Down
Straps
Install Foam Tape
Lay the Belt Rail Assemblies on top of the truck bed rail with the tab on the Tailgate Bracket toward the
center of the vehicle. The front of the rail should be 1-1/4” forward of the rear edge of the front wall of the
truck box.
Measure the distance between the inside edges of the right and left Belt Rail Assemblies at the front and
rear. Place them so that they are 63-1/2" at both places and are centered and square on the bed.
Install Belt Rail Assemblies
63-1/2"
63-1/2"
Front Edge of
Front Wall
Measurement between
Rails should be 63-1/2"
Belt Rail
Assembly
1/4"
Measure and cut a piece of Foam Tape that will fi t
the full length of the bottom of the Belt Rail Assem-
bly. Peel the backing off the tape a little at a time
and press the tape fi rmly into place on the Belt Rail
Assembly. Trim the tape to match the contour of the
Tailgate Bracket.
Repeat this with both Belt Rail Assemblies.
Tailgate Bracket
Rear Belt Rail
Peel Backing
off a little at
a time
Foam Tape
