Supertop for Truck Installation Instructions
Rev. G 0713
76303 pg. 10
Orient the Side Panels with the plastic J-Hook
toward the top and the zipper with the fl ap over
it toward the rear and determine which is for the
driver’s side of the vehicle and which is for the pas-
senger side.
Align the J-Hook on the top of the panel with the
J-Hook sewn into the top above the panel open-
ing. Slide them together. The J-Hook in the top is in
three pieces, so make sure that the J-Hook on the
Side Panel stays engaged through the splits.
Engage the front and rear zippers on the panel and
close them.
Work the plastic strip sewn into the bottom of the
Side Panel into the channel in the Belt Rail Assembly.
Fasten the Loop on the top of the Side Panel to the
Hook on the deck above the opening.
Repeat this procedure for the other Side Panel.
Zipper
Flap toward Rear
Tailgate
Opening
J-Hook
J-Hook
Install Side Panels
Side Rail
Plastic Strip - Slip
into Channel
Quarter
Panel
Adjust Tension on Top
Slide Front Bow
forward to increase
tension
Rolling the Rear Window
Roll Rear Window
Elastic Garters
Use the Elastic Garters on the Rear Bow to secure
the Rear Window in the open position. Unzip the
side zippers on the Rear Window, release the tail-
gate bar snap, and slide out the Tailgate Bar. Roll
the window from the bottom to the top and wrap an
Elastic Garter around each end of the window.
It may be necessary to increase the tension on the
top for a better fi t. In this case, move the Front Bow
forward to the next tooth in the Bow Mount Bracket.
Adjust the Tension Straps on the Rear Bow as nec-
essary for the best fi t.
