51254/51253 pg 3
0300 Rev. A
Seat Riser
Seat Track Slide
Track Bar
Re-Install Nuts -
Tighten to 21 Ft/Lbs.
Re-Install Nuts -
Tighten to 21 Ft/Lbs.
Failure to tighten the bolts and nuts to the specified torque can result in the seat loosening, thereby causing serious bodily injury to the vehicle occupants and to others.
WARNING
Step Two
Install the new riser, attaching it to the floor with the four bolts removed from the
old riser and torque to 34 ft/lbs.
Install the Seat in the Vehicle.
Place the seat in the vehicle. Align the studs on the tracks with the holes in the seat
riser. Reinstall the four (4) nuts that were removed in Step One on the track studs.
Tighten the nuts to 21 ft/lbs, using a #30 Torque Wrench.
If your seat track slide was not attached with nuts, follow, in reverse, the removal
procedure from Step One.
Left Side Shown
Re-Install Bolts -
Tighten to 34 Ft/Lbs.
