P6 - 44941 Rev. A 1216
Installation Instructions - Rear Bumper End Caps
© 2016 Bestop, Inc.
Page 6
Step 1
518.65
518.70 484.93
Step 2
Step 1
On the inside of the bumper, attach two (2) Inner
Frame Brackets #518.65, with two (2) M8-1.25x110
Bolts and two (2) M8 washers per bracket.
The Inner Brackets go over the top of the vehicle
horizontal frame member, and the bolts go up
through the bottom of the Bumper, around the
frame member, and into the brackets.
NOTE:
This hardware is from the Bumper
Installation kit.
Re-install the spare tire if you removed it earlier.
Step 2
Hardware
Tools
Inner Frame Bracket
Part #518.65
Qty. 2
M8 Flat Washer
Part #484.93
Qty. 4
M8-1.25x110
Hex Head Bolts
Part #518.70
Qty. 4
Socket wrench and
13mm & 19mm
sockets
(From Bumper Install Kit)
When all holes in the Bumper, Bumper
Bracket, and vehicle frame members are
aligned, attach the Bumper to the vehicle
frame using the three (3) #516.68 Bolts
and three (3) #414.17 washers per side.
NOTE:
This hardware is from the Bumper
Installation kit.
Section 5
Re-Attach Bumper to Vehicle (cont.)
