0704 Rev. A
41401 pg 3
Step Three
Install Cross Rails
Orient the Cross Rails with the large holes on the ends facing up and place them on
each set of Pillars.
Secure each Cross Rail to the Pillars using two 1/4-20 x 3/4" Pan Head Phillips
Screws, two 1/4" Internal Star Lock Washers and two 1/4-20 Hex Nuts for each rail.
Securely tighten all fasteners, including the screws that secure the Pillars to the roof.
Pillar
Cross Rail (Front Shown)
Front
1/4-20 x 3/4" Pan
Head Phillips Screw
Cross Rail
Pillar
1/4-20 Hex Nut
1/4" Internal Star
Lock Washer
Installation
Step One
I
NSTALL
R
EAR
P
ILLARS
ON
C
OCKPIT
C
OVER
Locate the four screws on the roof of the
Cockpit Cover. Turn them counter clockwise
to remove them.
Place a Gasket over each of the rear holes
with the rounded corners facing the outside
of the cover. Fill each hole with three 1/4"
Flat Washers. Place a Pillar over each Gas-
ket and install a 1/4-20 x 1" Hex Head Screw
with a 1/4" Internal Star Lock Washer. DO
NOT fully tighten the screws at this time.
Step Two
I
NSTALL
F
RONT
P
ILLARS
ON
C
OCKPIT
C
OVER
Place a Gasket over each of the front holes in the shell with the rounded corners
toward the outside of the shell. Fill each hole with three 1/4" Flat Washers.
Locate the Pillar Shims in the parts kit. They will be marked “Front Rt” and
“Front Lt” on the under side. Place the shims over the Gasket at the appropriate
hole in the shell with the rounded corners toward the outside of the shell. The
tall side of the Shim should be toward the front. Install a Pillar over each shim
using a 1/4-20 x 1-1/2" Hex Head Screw and a 1/4" Internal Star Lock Washer.
The sides of the Pillar should be flush with the Shim when the Shim is oriented
correctly. DO NOT fully tighten the screws at this time.
Rear
Pillar
1/4-20 x 1" Hex Head
Screw with 1/4" Internal
Star Lock Washer
Gasket
Gasket
Pillar Shim
Pillar
1/4-20 x 1-1/2"
Hex Head Screw
1/4" Internal Star
Lock Washer
