EZ Roll Tonneau Installation Instructions
Rev. A 0711
17182 pg. 3
With
Utilitrack
System
Standing in the bed if necessary, slide the ends of
the Front Rail on the Tonneau Cover Assembly into
the front Pivot Mounts on the Side Rails.
Install Tonneau Cover Assembly
Assemble Clamps
Use the 5/16" Bolts and 5/16" Lock Washers to
assemble the Large and Small Outer Clamps to the
Inner Clamps. Create six (6) Clamp Assemblies.
Inner
Clamp
Outer
Clamp
5/16"
Bolt
5/16"
Lock
Washer
Place Clamps
Use position that works
best for your vehicle
Tonneau Cover
Assembly
Front Rail
Front
Pivot
Mount
Front
Pivot
Mount
Unbuckle the Tie Down Straps. Press down fi rmly
on the end of the cover. Loosen the wing bolt and
slide the latch into the Side Rail. Tighten the wing
nut. Repeat on both sides of the vehicle.
Secure Tonneau Cover
Assembly
Both front latches must
remain engaged and the
wing bolts tight while the
cover is on the vehicle.
Unbuckle Tie
Down Straps
Wing Nut
With
Utilitrack
System
Inner
Clamp
Outer
Clamp
5/16"
Bolt
5/16"
Lock
Washer
Without
Utilitrack
System
Without
Utilitrack
System
It may be necessary to remove the torx screws
from the channel to allow the Inner Clamp to
slide into the channel.
Clamp positions may vary depending on any bed
accessories you may have.
If you do not have the Utilitrack system,
place two (2) Clamp Assemblies 6" from
each pivot mount. Place the third Clamp
Assembly 6" from the center of the Side
Rail.
If you have a Utilitrack system, slide the
Inner Clamp into the channel.
Do Not Tighten the Clamps at this time.
Repeat on both sides of the vehicle.
