SEtUP & InStaLLatIOn
6
Drilling a hole in a Stainless Steel Sink:
1. Locate an area on your sink to install the System Water Faucet
(make certain that there are no support ribs under the sink in
that location)
. Cover the designated location for the faucet
installation on sink with masking tape. Use the punch and
hammer to make a light indentation at the designated location
for the faucet installation.
(fig . G)
2. Using a 1/8” high speed drill bit, drill a pilot hole.
(fig . h)
3. Use a 9/16” high speed drill bit to enlarge the pilot hole.
(fig . I)
Proceed to “Faucet Installation” instructions on page 7.
WarnInG
Use ExtrEME CaUtIOn with electric power tools near water . Ensure that there
is no standing water in the sink and that the area is dry . Failure to follow this
warning could result in serious injury or death .
CautIon
this type of sink can be scratched easily . Use extreme care . If you have any
doubts about doing this yourself, consult a licensed plumber .
note
If your sink has another hole that currently has a spray attachment, you may
decide to remove the spray attachment, and use the existing hole to continue
your installation (skip the next section and go to “Faucet Installation”) .
1/8” High Speed Drill Bit
9/16” High Speed Drill Bit
Steel Sink Cross-section
Steel Sink Cross-section
G
h
I
