Best WPP9, Инструкция по эксплуатации и техническому обслуживанию, Страница: 15 / 72

- 15 -
INSTALL FILTERS
DUCTED AND NON-DUCTED HOODS
1. To remove the GREASE filter, (Fig.19) push
the filter towards the front so that it clears
the filter channel, then pull down on the
handle to disengage the filter from the
hood. Tilt the filter downward and remove.
2. The grease filters and the drip tray (see
page 5 for removal & cleaning instructions)
should be cleaned frequently. Use a warm
detergent solution. Grease filters and the
oil collectors are dishwasher safe.
3. To install the GREASE filter, align rear filter
tabs with spring in the hood. Pull down
handle, push filter into position and release.
Make sure the filter is securely engaged
after installation.
NOTE: Prior to use, remove protective film
from the filter frame.
NON-DUCTED HOODS (SINGLE MOTOR
VERSION
WPP9IQ only
)
1. Non-ducted recirculation filters not
included. They must be purchased
separately (ANKWPP9 Kit).
2. Using no.6 x 1/2” screws, install one filter
support on each side (provided) of the
internal blower (Fig.20).
3. Position each filter over its support, insert
both pins (B) into the round slot (C) on
filter side and rotate to lock in place
(Fig.21).
Non-ducted recirculation filters
The non-ducted recirculation filters should
be changed every 6 months. Rotate the filters
to remove and replace.
FIG. 19
FIG. 20
FIG. 21