BEST ACCESS SYSTEMS 1E Series, Руководство по обслуживанию

Страница: 92 / 96

BEST ACCESS SYSTEMS
Indianapolis, Indiana
.
3 Turn the cam to the 12 o’clock position as shown
in Figure 3.
4 With a BEST cylinder wrench, screw the cylinder
into the mortise case so that the figure-8 hole
stops in the 12 o’clock position and the set screw
is to the right.
Caution: Do not screw the cylinder in too
tightly. Doing so may cause you or someone
else to be locked out.
.
5 Tighten the set screw into the mortise case. This
prevents a thief from removing the cylinder and
figure-8 core.
6 Tighten the cylinder clamp screw as shown in
Figure 2.
3 Install core
1 Put the control key into the core and turn the key
15 degrees clockwise.
2 Adjust the throw pins if needed, then put the core
into the cylinder with the control key.
3 Turn the key 15 degrees counterclockwise and
remove the key.
Figure 2 Loosening the cylinder clamp screw
Cylinder clamp screw
Figure 3 Turning the cam to the 12 o’clock position
L
Cam in the
12 o’clock position